Adjustement Of Idling Speed; Adjustement Of Gas Clearance; Check And Adjustement Of Steering Gear - Beta REV-3 Manual Del Usuario

ADJUSTMENT OF IDLING SPEED ADJUSTMENT OF IDLING SPEED ADJUSTMENT OF IDLING SPEED
ADJUSTMENT OF IDLING SPEED ADJUSTMENT OF IDLING SPEED
In order to perform this operation
correctly, we advise you to do it when the
engine is hot, connecting an electric
revolution counter to the spark plug wire.
Then use a screwdriver on register screw
A A A A A to calibrate the minimum (1000 rpm).
ADJUSTMENT OF GAS CLEARANCE ADJUSTMENT OF GAS CLEARANCE ADJUSTMENT OF GAS CLEARANCE ADJUSTMENT OF GAS CLEARANCE ADJUSTMENT OF GAS CLEARANCE
Whenever the accelerator shows
unloaded travel exceeding 3 mm,
measured from the edge of the handle,
you should adjust it by means of
carburetor register B B B B B .
ADJUSTMENT AIR ADJUSTMENT AIR ADJUSTMENT AIR ADJUSTMENT AIR ADJUSTMENT AIR
It is advised from 1 1/2 to 2 1/4.
CHECK AND ADJUSTMENT OF CHECK AND ADJUSTMENT OF CHECK AND ADJUSTMENT OF CHECK AND ADJUSTMENT OF CHECK AND ADJUSTMENT OF
STEERING GEAR STEERING GEAR
STEERING GEAR STEERING GEAR STEERING GEAR
Periodically check the play in the steering
sleeve by moving the fork back and forth
as shown in the figure. Whenever you feel
play, adjust as described below:
•Unscrew the 4 screws C C C C C
•Remove handlebar D D D D D
•Loosen nut E E E E E
•Take up the play by means of ring nut F F F F F .
For reassembly. proceed in the reverse
order.
65
4
GB