Clutch Pump Oil - Beta REV-3 Manual Del Usuario

CLUTCH PUMP OIL

CLUTCH PUMP OIL CLUTCH PUMP OIL
CLUTCH PUMP OIL CLUTCH PUMP OIL
Check the oil level. The oil level must never
be below half the tank capacity.
To restore the oil level, top up by unscrewing
the two screws A A A A A , lifting cop B B B B B and adding
oil.
Note: Note:
Note: Note: Note:
For oiI changes, follow the instructions
given on the chart on pag. 62, using the
Iubricants recommended on pag. 47
Bleeding of clutch Bleeding of clutch Bleeding of clutch
Bleeding of clutch Bleeding of clutch
To bleed air from the clutch circuit, proceed
as follows:
•Remove the rubber cap from valve C C C C C
•Open the oiI sump cap
•Insert one end of a tube into valve D D D D D
and the other end into a container
•Unscrew the valve and pump with the
clutch lever until obtaining a continuous
outflow of oil with no air bubbles. During
this procedure, you must continuously top
up the clutch pump tank to repose the oil
that is removed
•Tighten the valve and replace the rubber
cap
•Remove the tube.
Note: Note: Note: Note: Note:
Handle the hydraulic oiI very carefully. It
is corrosive, and will irreparably damage
painted or plastic parts of the motorcycle
upon contact.
53
3
GB