Multichannel Systems; Changing Carrier Frequencies - AKG WMS 40 FLEXX Modo De Empleo

Switch the transmitter on, move closer to the receiver, or set the
squelch threshold to the point that the green RF OK LED (3a) will be
lit.
3. If the received signal is noisy, set the squelch threshold to a level
where the noise will stop.
• Never set the squelch threshold any higher than absolutely nec-
essary. The higher the squelch threshold (-70 dB = max., -100 dB
= min.), the lower the sensitivity of the receiver and thus the us-
able range between transmitter and receiver.
The spacing between the three carrier frequencies of each WMS 40
FLEXX is wide enough for operating three radio channels simultaneously
within the same frequency band with no mutual interference.
For systems with up to nine channels you will need WMS 40 FLEXX kits
in up to three different frequency bands. Please ask your dealer which
frequency bands are suited for multichannel use and approved for the
place where you will use the system. Perform steps 1 through 6 for each
frequency band separately.
1. Switch power to all transmitters and receivers off.
2. Set the frequency selectors on the transmitter and receiver for chan-
nel 1 to "1".
3. Set the frequency selectors on the transmitter and receiver for chan-
nel 2 to "2".
4. Set the frequency selectors on the transmitter and receiver for chan-
nel 3 to "3".
5. Set up the transmitter and receiver for channel 1.
6. Repeat steps 1 through 5 for channels 2 and 3.
• Never operate two or more wireless channels on the same fre-
quency at the same time and location. This would cause un-
wanted noise due to radio interference.
• Prior to changing a carrier frequency, be sure to switch the transmit-
ter off. To activate the new carrier frequency, switch the transmitter
back on.
AKG WMS 40 FLEXX
3 Setting Up
L
3.9 M M ultichannel
Systems
Note:
Refer to fig. 17
on page 100.
Refer to sections 3.1
through 3.8 above.
L
3.10 C C hanging
Carrier F F requencies
! Important!
! Important!
31