Hoshizaki KM-320MAH-E Manual De Instalación página 5

Ocultar thumbs Ver también para KM-320MAH-E:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
7. Startup
WARNING
1. This icemaker is designed to produce edible
ice. To keep the icemaker sanitary:
• Wash your hands before removing ice.
• Use the plastic scoop provided (accessory).
• Keep the scoop clean. Clean it by using a
neutral cleaner and rinsing thoroughly.
• The storage bin is for ice use only. Do not
store anything else in the bin.
• Close the door after removing ice to
prevent entrance of dirt, dust or insects
into the storage bin.
2. The use of any electrical equipment involves
the observance of some fundamental rules.
In particular:
• Instances of high humidity and moisture
increase the risk of electrical short circuits
and potential electrical shocks. If in doubt,
disconnect the icemaker.
• Do not use the icemaker when you have
bare feet.
• Do not pull the power cord in order to
disconnect the icemaker from the feed
network.
• This appliance is not suitable for
unsupervised use by young children or
aged or infirm persons.
3. All parts are factory-adjusted. Improper
adjustments may result in failure.
4. If the unit is turned off, wait for at least
3 minutes before restarting the icemaker to
prevent damage to the compressor.
5. Do not operate the unit in the "WASH"
position without water in the water tank. This
will cause damage to the water pump seal.
1) Open the water supply line shut-off valve.
2) Remove the front panel.
3) Move the control switch, on the control box, to the
"ICE" position.
4) Replace the front panel in its correct position.
5) Turn on the power supply and allow the water
tank to fill with water and the icemaker to operate
for a total of 10 minutes. (See 8 for Sequence of
Operation).
6) Turn off the power supply, and remove the front
panel and the base cover.
7) Remove one end of the pump tubing and drain the
water tank, (See Fig. 4) to flush any loose debris.
8) Replace the pump tubing and the base cover in
their correct positions.
9) Clean the storage bin.
10) Replace the front panel in its correct position.
11) Turn on the power supply, and start the automatic
icemaking process.
12) Wait until a complete icemaking and defrost cycle
is completed.
Bin Control Check
To confirm bin control operation, press the bin
control's actuator paddle during the first 5 minutes
of the freeze cycle. The icemaker should stop within
15 seconds.
5
ENGLISH
Fig. 4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Km-515mah-eKm-650mah-e

Tabla de contenido