Fagor LFA-073 IT Manual De Instruciones Y Mantenimiento página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DRAINAGE
Connect the drainage
pipe incorporated into
a waste disposal unit,
on a drainage pipe tap
or in a residual gap
depending on plumbing
standards in force.
It is possible to lengthen
the drain pipe with
material resistant to hot
water and detergent.
Always keep an inner
diameter of at least 5/8"
(1.5875 cm). Never
exceed the maximum
distance of 9" (22.86
cm) to the drainage
piping.
Raise the drain pipe and
fasten it to the lower part
of the worktop. Lower it
again to the drainage
connection point
following these
instructions:
1. The connection with
the drain pipe must be
at least 10" (25,4 cm)
from the floor.
2. The connection with
the drain pipe must be
no higher than 35" (88.9
cm) from the floor.
In order to make
installation easier, the
dishwasher includes an
assembly bracket for
curved drain pipes.
I M P O R TA N T
It is important that the bend of the drainage hose is properly anchored in the outlet to avoid
falling out and the consequent risk of flooding. The (minimum and maximum) water operating
pressure must fall between 0.05 and 0.1 Mpa. Make sure that the connector for the appliance's
lower pipe is properly adjusted before installing.
With an air gap
Sink
Min. 10"
Sink
Garbage
disposal unit
Min. 10"
Without an air gap
Sink
Min. 10"
Sink
Garbage
disposal unit
Min. 10"
Diswasher
Max. 35"
Diswasher
Max. 35"
Diswasher
Max. 35"
Diswasher
Max. 35"

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Lfa-073 ssLfa-65 itLfa-65 ssLfa-65 itx

Tabla de contenido