Fagor LFA-073 IT Manual De Instruciones Y Mantenimiento página 10

DOOR
There is a useful template
with the assembly
instructions.
h Fit the corresponding
template (J-120:K-110),
fasten it down and mark
the position of the holes.
Drill, using a Ø 1,16" bit
i
and screw in the supports
(part which curves
upwards) to the
decorative door.
Take the Decorative Door
j
and slide the supports
into the door slots. Pull
up until touching the
control panel making sure
that it has been properly
fixed down.
k
Open the dishwasher
door slowly holding the
decorative door and
finally fix it with the screws
taking care to align the
panel with the door.
In the event that the
l
door springs are not
strong enough,
compensate for this
with the two additional
screws supplied in the
accessories bag.
Fit the panel on the
m
kitchen appliance,
tightening it until the
desired measurement
is obtained.
Fix the dishwasher to
n
the worktop if it is
made of wood. If the
worktop is made of
granite, fix the
dishwasher to the
adjoining furniture.
h
j
I M P O R TA N T
The maximum and minimum weight which is recommended
for the decorative door to be fitted on the dishwashers is:
Maximum 14 lb. Minimum: 6,5 lb.
l
n
I M P O R TA N T
A space of at least two millimetres must be left at the
sides between the kitchen fittings or electrical appliances
and the dishwasher.
English
i
k
m
n
9