End Of Program - Fagor LFA-073 IT Manual De Instruciones Y Mantenimiento

5
START UP
Once the wash program has been chosen and the additional functions selected, close
the dishwasher door and it will start up automatically.
When the dishwasher is operating and...
– You wish to put another piece in the dishwasher.
– You wish to change the wash program.
1. Open the dishwasher door.
2. Put the piece in the dishwasher and/or modify the wash program
3. Close the dishwasher door.
If the modification interferes with the duration of the selected wash program or if it is
the delay option then press the ON/OFF first to change status
6

END OF PROGRAM

Once the program has finished, the
dishwasher will beep continuously for
3 seconds.
When opening the dishwasher door,
you can verify the wash finish by
checking a light on the door edge.
7
POWER CUTS
If there is a power cut, when the power comes back on the dishwasher will continue its normal
operation from the point where it was stopped (it has a minimum memory of 12 hours, depending
on the model).
8
BASIC RECCOMMENDATIONS
There are a series of issues which must be taken into consideration to help your dishwasher last
longer and wash better.
a Fill the dishwasher. Try to make the most of the dishwasher capacity and so reduce
water and electricity consumption and lead to quieter operation.
Position the dishes properly. For optimum wash quality, the water spray arms must
b
turn freely without obstacles. In the same way, the pieces must be correctly positioned for
the water jet to reach them.
c
Choice of program. Choose the wash program and the additional functions properly,
according to your needs.
Cleaning. Clean the filters and the water spray arms every three months. Also make sure
d
that they are correctly refitted.
0 0
MODELS
DISPLAY
END