Fein MM 500 Plus Serie Instrucciones De Uso página 18

en
18
Repair and customer service.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
Exchangeable parts
If required, you can change the following
parts yourself:
Application tools
Service.
Have maintenance carried out
WARNING
only through qualified person-
nel. Incorrectly mounted leads and compo-
nents can cause serious injuries. Have the
required service carried out only through a
FEIN customer service agent.
The current spare parts list for this power
tool can be found in the Internet at
www.fein.com.
Use only original spare parts.
Cleaning.
Prior to any cleaning or main-
WARNING
tenance, disconnect the
power tool from the power supply in order to
avoid accidents.
When using in environments
WARNING
with conductive dust in the
air, such as when working metals, this dust
can settle in the interior of the power tool.
This can impair the total insulation of the
power tool. Therefore, regularly blow out the
interior of the power tool from outside via the
ventilation openings with dry, oil-free com-
pressed air; always wear eye protection when
doing this. For additional protection, connect
a residual current device (RCD) on the line
side.
Do not attempt to clean
CAUTION
clogged or dirty ventilation
openings of the power tool with pointed
metal objects; use nonmetal tools or objects
if necessary.
Do not use cleaning agents
CAUTION
and solvents that can cause
damage to plastic parts. These include: Gas-
oline, carbon-tetrachloride, chloric solvents,
ammonia and domestic cleaning agents that
contain ammonia.
When the machine's power
CAUTION
supply cord is damaged, it
must be replaced by the manufacturer or their
representative.
When working gypsum-containing materials,
dust can settle within the power tool and
switch element, which can harden in connec-
tion with humidity. This can impair the
switching mechanism. Blow out the interior
of the power tool via the ventilation slots and
the switch element frequently with dry and
oil-free compressed air.
Products that have come into contact with
asbestos may not be sent in for repair. Dis-
pose of products contaminated with asbestos
according to the applicable country-specific
regulations for such disposal.