Fein MM 500 Plus Serie Instrucciones De Uso página 6

en
6
Hot mixtures of sanding dust and paint/var-
nish remainders or other chemical materials
in the filter bag or the vac filter can self-ignite
under unfavorable conditions, such as spark-
ing from sanding metal, continuous sunlight
or high ambient temperatures. To prevent
this:
Hand/arm vibrations.
While working with this power
WARNING
tool, hand/arm vibrations
occur. These can lead to health impairments.
The vibration emission value
WARNING
during actual use of the power
tool can differ from the declared value
depending on the ways in which the tool is
used.
It is necessary to identify safety
WARNING
measures to protect the oper-
ator that are based on an estimation of expo-
sure in the actual conditions of use.
The vibration emission level given in this
information sheet has been measured in
accordance with a standardized test given in
EN 62841 and may be used to compare one
tool with another. It may be used for a pre-
liminary assessment of the vibrational impact.
Emission values for sound and vibration (Two-figure – specifications as per ISO 4871)
Sound emission
A-weighted emission pressure power level measured at the workplace
L
(re 20 μPa), in decibels
pA
Measuring uncertainty
Measured A-weighted sound power level
Measuring uncertainty
C-weighted peak sound pressure level measured at the workplace
L
, in decibels
pCpeak
Measuring uncertainty
REMARK: The sum of the measured emission value and respective measuring inaccuracy
represents the upper limit of the values that can occur during measuring.
Wear hearing protection!
Measured values determined in accordance with the corresponding product standard.
K
, in decibels
pA
K
, in decibels
wA
K
, in decibels
pCpeak
– Avoid overheating the material being
sanded and the power tool.
– Empty the dust collector/container in time.
– Observe the material manufacturer's
working instructions.
– Observe the relevant regulations in your
country for the materials being worked.
The declared vibration emission level repre-
sents the main applications of the power tool.
However, if the power tool is used for other
applications with different accessories or
poorly maintained, the vibration emission
may differ. This may significantly increase the
vibrational impact over the total working
period.
An estimation of the level of exposure to
vibration should also take into account the
times when the tool is switched off or when
it is running but not actually doing the job.
This may significantly reduce the vibrational
load over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration
such as: Maintain the power tool and the
accessories, keep the hands warm, organiza-
tion of work patterns.
L
(re 1 pW), in decibels
wA
MM 500 Plus (**)
74.1
3.0
85.1
3.0
87.2
3.0