Silca Tri-Code Manual De Uso página 31

Operating manual - English
During the cutting operation the following message appears:
The value 'Axis: 1' appears during cutting of the 1st axis.
Going on to cut axis 2, the following message appears:
When side A has been cut the following message appears:
Raise the safety shield, loosen the (F) knob remove the key, turn it 180°, replace on the clamp (clamp
A and Stop 2) and lock the (F) knob.
Lower the safety shield and press START.
The value 'Axis: 1' appears during cutting of the 1st axis.
Going on to cut axis 2, the following message appears:
When the cutting operation is complete, the following message appears:
Press
Press [STOP] to end the operation.
26
C l a m p : A
C u t t e r : H 1 0 1
K e y o n s i d e A
P c s = 1 / 1
C U T T I N G I N P R O G R E S S
C o p y : 1 o f : 1
S i d e : A
A x i s : 1
C U T T I N G I N P R O G R E S S
C o p y : 1 o f : 1
S i d e : A
A x i s : 2
C l a m p : A
C u t t e r : H 1 0 1
K e y o n s i d e B
P c s = 1 / 1
C U T T I N G I N P R O G R E S S
C o p y : 1 o f : 1
S i d e : B
A x i s : 1
C U T T I N G I N P R O G R E S S
C o p y : 1 o f : 1
S i d e : B
A x i s : 2
C o p y : 1 o f : 1
f i n i s h e d !
M o r e c o p i e s ?
N o = S T O P Ye s = E N T E R
[ENTER] to proceed with another copy.
Copyright Silca 2006
P o s . : 2
D i a l : 5
[ S T A R T ]
P o s . : 2
D i a l : 5
[ S T A R T ]
TRI-CODE H.S.