Cutter Calibration - Silca Tri-Code Manual De Uso

Operating manual - English
5.6.2

Cutter calibration

Note: the TRI-CODE H.S. key-cutting machine is already gauged when delivered. In the event of replacing the cutter
or checking cutting depth gauging, proceed as follows:
First check that clamp, cutter and Z22 template are all perfectly clean.
Choose the function from the main menu by placing the cursor on "3 - Calibrations".
Press ENTER, the display shows:
Select "2 - Cutters".
the display will show:
Check that the H101 (Standard) cutter is installed. If not, see ch. 4.6 "Changing the cutter and/or the
tracer point".
Press ENTER, the display shows:
Press ENTER, the display will show:
Fig. 32
Raise the safety shield, loosen the (F1) handle by one turn and pull the anatomic grip (F2) towards the
operator. This releases the clamp so that it can slide to the right. Release the anatomic grip, move the
clamp manually and the positioning device will lock the clamp into the clamp reference notch. When the
clamp is in position (Clamp A) tighten the (F1) handle.
Turn the (F) knob to the left.
Fit the Z22 template into jaw A so that it lies flat on the clamp with the area marked B up against Stop
2 (to do this, turn the Stop 1 plate to the left and downwards).
Secure the Z22 template by turning the (F) knob to the right.
1 - C l a m p
2 - C u t t e r
3 - T r a c e r p o i n t
C u t t e r
1 : H 1 0 1
C a l i b r a t e h e i g h t
c u t t e r H 1 0 1
[ E N T E R ]
C l a m p : A
T e m p l . : Z 2 2 - B P o s . : 2
S e e o p e r a t i n g m a n u a l .
[ E N T E R ]
Copyright Silca 2006
F
F2
F1
TRI-CODE H.S.
39