Silca Tri-Code Manual De Uso página 50

Operating manual - English
- Loosen the grub screw (K) (fig. 41) only slightly so that the decoder does not fall out.
Fig. 41
- Regulate the cam screw (K2) so that the decoder is lowered gradually until it touches the area
marked C on the Z22 template. On achieving this (Electric Contact made), the decoder change of
status from OFF to ON will be signalled by a beeper and shown on the display:
- Tighten the grub screw (K) to secure the decoder.
- Press STOP to quit the menu. Turn off the key-cutting machine.
- Turn the dial unit to the left until it reaches position 10 (you should hear it click into place)
- Move the carriages manually to take them back to their initial position (take care not to bang into the
tools).
- Tighten the grub screw (K1) (fig. 38, page 43).
- Turn the (F) knob to the left and remove the Z22 template.
O
7 E L E C T R I C C O N T A C T
M a k e a c o n t a c t
C U T T E R
S t a t . : O F F
Copyright Silca 2006
K2
K
T R A C E R
S t a t . : O N
TRI-CODE H.S.
45