Decoder Calibration - Silca Tri-Code Manual De Uso

Operating manual - English
5.6.3

Decoder calibration

Note: the TRI-CODE H.S. key-cutting machine is already gauged when delivered. In the event of replacing the
decoder (Ch. 7.12) or checking cutting depth gauging, proceed as follows:
First check that clamp, decoder and Z22 template are all perfectly clean.
Choose the function from the main menu by placing the cursor on "3 - Calibrations".
Press ENTER, the display will show:
Select "3 - Decoder". The display will show:
Check that the U111DC decoder on the machine is in good condition. If not, see ch. 7.12
"Decoder (U111DC) replacement".
Press START, the display will show:
Z22
Fig. 36
Loosen the (F1) handle by one turn and pull the anatomic grip (F2) towards the operator. This releases
the clamp so that it can slide to the right.
Release the anatomic grip, move the clamp manually and the positioning device will lock the clamp into
the clamp reference notch. When the clamp is in position (Clamp A) tighten the (F1) handle.
Turn the (F) knob. to the left. Fit the Z22 template into jaw A so that it lies flat on the clamp with the area
marked A up against Stop 2 (to do this, turn the Stop 1 plate to the left and downwards). Secure the Z22
template by turning the (F) knob to the right.
Press ENTER; the display will show the message:
42
1 - C l a m p
2 - C u t t e r
3 - T r a c e r p o i n t
T R A C E R
A d j u s t m e n t :
U 1 1 1 D C : X = - 0 2 Y = - 1 8
T o c a l i b r a t e [ S T A R T ]
C l a m p : A
T e m p l . : Z 2 2 - A P o s . : 2
S e e o p e r a t i n g m a n u a l .
[ S TA R T ]
F2
F1
D e t e c t i o n
i n p r o g r e s s !
Copyright Silca 2006
Z22
TRI-CODE H.S.
U111DC
F