Messages; Error Messages - Silca Tri-Code Manual De Uso

Operating manual - English
5.9

MESSAGES

5.9.1

ERROR messages

The message appears when there are problems updating the machine program.
Try updating or re-loading the machine program using the WINTRANSFER program.
Calibration of the "Machine Zero Points" reveals a contact failure between the two templates used
(template Z21 and tracer point U111) (Ch. 5.7.4, page 52).
A machine zeroing procedure (calibration) has been started on the clamp. One of the following
situations has occurred:
• the tracer point or cutter has not been fitted.
• the clamp required for the procedure started is not properly fitted.
• the template is not in position on the clamp.
The Y axis is not detected during gauging.
Check the condition of the U111 tracer point and the position of the Z22 template.
The Machine ID has not been set. In such cases access cannot be gained to Protected Systems until
the Machine ID is set. Select menu 5-7-1 and check that the Machine ID is different from 0.
To set Machine ID ask for a Software update valid for your machine (machine internal program version
higher than or the same as 2.0.040) and install with the SILCA WinTransfer Program.
In the Options menu - Preferences - Select Make, the makes in the list have been deselected. Select
at least one make in order to proceed.
E R R O R 1
I S O f u n c t i o n
n o t d e f i n e d !
E R R O R 2
Te m p l a t e e r r o r !
N o c o n t a c t m a d e .
S e e o p e r a t i n g m a n u a l .
E R R O R 3
X A x i s N o c o n t a c t
m a d e !
E R R O R 4
Y A x i s N o c o n t a c t
m a d e !
E R R O R 5
M a c h i n e I D
n o t d e f i n e d !
S e e o p e r a t i n g m a n u a l .
E R R O R 6
P i c k a t l e a s t o n e
m a n u f a c t u r e r !
[ E N T E R ]
Copyright Silca 2006
TRI-CODE H.S.
61