Disposing Of Machine - Silca Tri-Code Manual De Uso

Operating manual - English
8

DISPOSING OF MACHINE

To dispose the machine, it must be rendered unusable by carrying out the operations listed below
• deactivation of the electricity supply;
• separation of the plastic and metal parts;
• remove the lithium battery from the electronic board;
Attention: the lithium battery must be disposed in the special containers.
When these operations have been carried out the machine can be disposed of according to the current
regulations in the country of use.
M
ACHINE
TRI-CODE H.S. is a durable machine and is also re-usable.
Recycling is an ecologically sound practice to be recommended.
P
ACKING
As the packing in which the TRI-CODE H.S. key-cutting machine is transported is made of cardboard
and wood it can be re-used if intact or used as fuel for the production of heat (e.g. wood-fired stoves) if
dismantled.
Warning! Take great care when dismantling the packing as it contains nails, the points of which will be
exposed. Bend them down into the wood with a hammer or remove separately and dispose of them in
an authorized metal recycling centre.
As waste the packing is considered solid urban waste and must not be thrown into the environment but
taken to the special collection centres.
W
ASTE DERIVING FROM KEY CUTTING
Waste deriving from key cutting is classified as special waste, but included in solid urban waste,
considered as metal wool. Such waste must be disposed of in the special collection centres according
to the classification assigned to them by current law.
84 Copyright Silca 2006
TRI-CODE H.S.
: