Various Messages - Silca Tri-Code Manual De Uso

Operating manual - English
The selected data card allows cutting by indirect code only.
Indicates that the machine has been turned on again after an interruption.
Press START to continue (Ch. 5.9.5 "INTERRUPTIONS", page 66).
Indicates that the cutting cycle has been interrupted (with STOP) (see Ch. 5.9.5, page 66).
Consult the manual (for the operation required) and press ENTER to continue.
5.9.4

Various messages

Appears
• If the template is not found during gauging.
• If the key is not in the clamp.
Appears
• if the decoder is broken or missing,
• if the decoder is not properly gauged (decoder too high),
• if the clamp is installed in a different position (A, B or C),
• if the clamp is not installed, (***) = A, B or C
If the previous operation required the dial to be in a position different from 5 (e.g. 6) and the operator
forgets to take the dial back to position (5), the display will show the message:
A T T E N T I O N
T h e a c c e s s t o t h i s
s e r i e s ( S S N ) i s o n l y
t h r o u g h t h e c o d e
A T T E N T I O N
T h e m a c h i n e w a s
t u r n e d - o f f d u r i n g
a w o r k c y c l e !
A T T E N T I O N :
C y c l e i n t e r r u p t e d !
K e y w i l l b e d a m a g e d
[ E N T E R ] [ S TA R T ]
A T T E N T I O N
S e e o p e r a t i n g
m a n u a l b e f o r e
p r o c e e d i n g ! [ E N T E R ]
X A X I S E R R O R
N o c o n t a c t
m a d e !
E R R O R
C l a m p ( * * * )
n o t i n s t a l l e d
c o r r e c t l y !
U n l o c k t h e l e v e r a n d
r e g u l a t e t h e d i a l
t o p o s i t i o n 5
[ S TA R T ]
Copyright Silca 2006
TRI-CODE H.S.
65