Sony MEX-100NV Manual De Instrucciones página 46

Einbauanl_CD5_0.book Seite 44 Montag, 1. Juli 2002 2:38 14
Installation guide
Status of calibration ride (
In the Service Mode, select
control and press to confirm.
The calibration status (e.g.
) are displayed. After completing calibration, the street in which you
3D
are currently driving is displayed (provided that it is digitised) instead
of and .
WHEEL REV.
Testing the system components (
A test program automatically tests the internal components of the navi-
gation system.
In the Service Mode, select
and press to confirm.
If OK is displayed, press NAVI. The unit switches back to the Service
Mode.
Function test of the GAL signal, reverse signal, internal sensors
( )
SENSORS
• In the Service Mode, select
and press to confirm.
• Move the vehicle several metres forwards or backwards for the
GAL signal function test.
The number after
speed).
The number after
pressing the accelerator when the vehicle is parked.
Subject to correction and technical modifications
)
CALIBRATION RIDE
using the SELECT
CALIBRATION RIDE
) and the type of positioning (e.g.
STATE: 2
MODULE TEST )
MODULE TEST using the SELECT control
using the SELECT control
SENSORS
should increase (even at a low
WHEEL:
should not increase if idling or
WHEEL:
44
CALIBRATION
C A L I B R A T I O N R I
MODULE TEST
STATE: 2 3D_FIX
MAINSTREET
11:38.34E 54:49.14N
CALIBRATION RIDE
M O D U L E T E S T
SENSORS
MODULE TEST
S E N S O R S
SPEECH TEST
WHEEL: 35150 REV.: 0
GYRO: 10
X: _29 Y: _31
Copyright by Becker GmbH, D-76303 Karlsbad