Epson SureColor S Serie Guía De Referencia Rápida página 11

Raise the media loading lever, then pull out the media by hand and insert it into the printer.
7.
Note: If the media is heavy and difficult to unroll, press the
drive switch on the left roll holder. Press the switch up or
down based on the orientation of the paper on the roll. You
can also pull out the media manually.
Insert the media past the pressure rollers.
8.
Make sure the left edge of the media passes over the center of the square in the label on the pre-heater
(the media sensor). To avoid media skew, feed extra media, then use the motor to wind it back on the
roll.
Caution: If the left edge of the media is not in the
right position, perform steps 7 to 2 in reverse
order and restart the loading process. Do not
attempt to reposition the roll holders while they
are inserted in the media roll.
Loading Media |
9
Printable
side out
Printable
side in