Layout Torage; Storage; Lv- Modification To Cabinet Layout; Commissioning Your Wine Cabinet - Eurocave Compact Modo De Empleo

6- L
IV - Modification to cabinet layout
To change the position of a storage shelf, first of all completely unload the shelf, and move the
shelf supports taking care to re-attach them as shown opposite:
To change the position of a sliding shelf, first of all completely unload the shelf. Then lift the sliding shelf and slid it towards you whilst holding the front of
it upwards. Remove the wall slider guides, marking which is right and which is left, then reinstall them as shown below:
Wall
Guide
Wall
Guide
Then replace the sliding shelf as shown opposite:
7 - C
1- Connection
Check that the plug is connected to a power supply (presence of correct amp fuses, functioning
30 mA* differential circuit breaker (*not applicable to certain countries).
Make sure you wait 48H before commissioning.
I1- Switching on
Press the "U" button, located on the adjustment panel until the display is activated. When the
adjustment function is starting up, the message "OD" will appear. Wait for the temperature to be
displayed – do not touch any of the control buttons or unplug the appliance during this time.
10
– S
AYOUT
Installing the rear section
of the guide
Sliding shelf
Guide
OMMISSIONING YOUR WINE CABINET
TORAGE
Installing the front section
of the guide
Guide
Shelf
support
Wall
Guide
Wall
Wall