Siemens 1FK6 Instrucciones De Servicio página 189

08.2009
Removing the
optional board
Mounting the
optional board
Mounting the option
card holder
Siemens AG 6SE7087-8JP50
SIMOVERT MASTERDRIVES
♦ Undo the two optional board screws by about one turn each.
♦ Loosen the connection between the system connector and the
board so as to prevent any mechanical tension arising when the
screws are fully unscrewed.
♦ Take out the optional board screws and remove the board.
♦ Insert the optional board from the behind the broken-out slot conver
( ) until the position of the 64-pole system connector on the
electronic board corresponds with the position of the socket.
♦ Insert the option board into the 64-pole system connector on the
electronic board (
♦ Screw the optional board tight at the fastening points in the front
section of the optional board with the two screws (
Slot C
Fig. 5-10 Installing the optional board
Place the option card holder horizontally on the rear edge of all fitted
option cards and tighten the previously removed screws at the fixing
points.
Operating Instructions
).
Installation
).
Slot C
5-11