Potential Hazards During Electric Arc Welding - Parkside PFDS 33 B4 Instrucciones De Funcionamiento Y De Seguridad

Safety instructions
Wear gloves and dry
protective clothing that are
free of oil and grease to
protect the skin from exposure
to ultraviolet
radiation of the arc.
welding power source
to defrost pipes.
Please note:
The light radiation emitted by
„
the electric arc can damage
eyes and cause burns to the
skin.
Arc welding creates sparks
„
and drops of melted metal.
The welded workpiece starts
to glow and remains hot for
a relatively long period.
Therefore, do not touch the
workpiece with bare hands.
Arc welding can cause
„
vapours to be release that
may be hazardous to health.
Be careful not to inhale these
vapours.
Protect yourself from the
„
harmful effects of the electric
arc and keep people that are
not involved in the work away
from the arc maintaining a
distance of at least 2 m.
78 GB/MT
Do not use the
ATTENTION!
During the operation of
„
the welding device, other
consumers may experience
problems with the voltage
supply depending on the
network conditions at the con-
nection point. In case of doubt,
please contact your energy
supply company.
During the operation of the
„
welding device, other devices
may malfunction, e.g. hearing
aids, cardiac pacemakers, etc.
z Potential hazards during
electric arc welding
There are a series of potential
hazards that can occur during
electric arc welding. It is there-
fore particularly important for the
welder to observe the following
rules to avoid endangering him/
herself and others and to prevent
damage to people and the
device.
Work on the voltage side,
„
e.g. on cables, plugs, sockets
etc., may only be carried out
by qualified electricians
according to national and
local regulations.
In the event of accidents,
„
disconnect the welding