Potential Hazards During Electric Arc Welding - Parkside PMSG 200 A1 Instrucciones De Funcionamiento Y De Seguridad

Safety instructions
conditions at the connection
point. In case of doubt, please
contact your energy supply
company.
During the operation of the
„
welding device, other devices
may malfunction, e.g. hearing
aids, cardiac pacemakers, etc.
z Potential hazards
during electric arc
welding
There are a series of potential
hazards that can occur during
electric arc welding. It is there-
fore particularly important for the
welder to observe the following
rules to avoid endangering him/
herself and others and to prevent
damage to people and the
device.
Work on the voltage side,
„
e.g. on cables, plugs, sockets
etc., may only be carried
out by qualified electricians
according to national and
local regulations.
In the event of accidents,
„
disconnect the welding
devoice from the mains
voltage immediately.
If electrical contact voltages
„
occur, switch off the device
68
GB/MT
immediately and have it
checked by a qualified
electrician.
Always ensure good electrical
„
contacts on the welding current
side.
Always wear insulating gloves
„
on both hands during welding
work. These provide protection
from electrical shocks (no-load
voltage of the welding current
circuit), harmful radiations
(heat and UV radiation)
and incandescent metal and
splashes of slag.
Wear sturdy, insulating shoes.
„
The shoes should also insulate
when exposed to moisture.
Loafers are not suitable as
falling incandescent metal
droplets can cause burns.
Wear suitable protective cloth-
„
ing, no synthetic garments.
Do not look into the electric
„
arc without eye protection;
only use a welding mask with
the prescribed protective glass
as per DIN. In addition to light
and heat radiation, which
can dazzle or cause burns,
the electric arc also emits UV
radiation. Without suitable
protection the invisible ultravi-
olet radiation can cause very
painful conjunctivitis which