Trix Big Boy Manual Del Usuario página 41

G Operation with antipole direct voltage in the bra-
king section is not possible with DCC operation.
G Malfunctions resulting from changes to the factory
settings of the locomotive electronics are caused
by the operator and do not give grounds for com-
plaint under our guarantee or warranty obligations.
G The installed locomotive electronics offer a wide
range of adjustment options according to the
NMRA/DCC standard. A series of parameters are
stored to this end in what are known as CVs
(abbreviation for Configuration Variable). Please
refer to the operating instructions for your system
for the procedure for changing these setting
values. This operating system must comply with
NMRA/DCC standards if a perfect programming
function is to be guaranteed. The use of an un-
suitable operating system does not give grounds
for complaint under our guarantee or warranty
obligations.
G We recommend that you always change just one
setting value and see what effect this has.
G Before changing parameters, you must remove
any smoke generators that have been fitted.
G The list below gives only the sensible CV registers
with the possible parameters. A list of all possible
CVs can be obtained on the Internet from the
website www.loksound.de of ESU Electronic
Solutions Ulm GmbH. Under "Downloads", select
the decoder "Loksound 2". This website is available
in English and German. The CVs shown in the
following blocked list must not be changed under
any circumstances!
G CV 8 is an important CV. Writing the value "8"
will result in the complete component being reset
to the factory settings that applied at the time of
delivery!
41