The Handheld Transmitter Lcd - Dogtra ARC 1200S Manual De Usuario

1. Attach the charging cables to both the transmitter and
receiver(s), as shown on page 47.
2. Plug the charger into a 120-volt wall outlet or if using
only for Lithium-Polymer batteries (use a 230-volt
European charger for Europe.). When properly plugged
in, all indicator lights should glow red. During the
charging process, the unit will shut off. Once the battery
cable is unplugged from the unit after a full charge,
you will need to turn the unit on again before use.
3. The Lithium-Polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process. The red light will change into a steady green light
when the battery is fully charged (when you disconnect
restart the unit).
4. After charging, cover the battery charging receptacles
with the rubber plugs on the transmitter and receiver/
collar.
NOTE : Only use Dogtra-approved batteries, chargers, and
accessories for your Dogtra e-collars. When a charger is not
in use, disconnect it from the power source.

8. THE HANDHELD TRANSMITTER LCD

48
Turn the LCD backlight on and off with a short press of
the on/off button.
The LCD screen indicates the stimulation level (0-127).
The LCD battery life indicator shows 3 bars at full charge,
2 bars at medium charge and 1 bar when it needs to be
your receiver, observe the LED indicator on the receiver/collar.
Green = full charge
Amber = medium charge
Red = needs charge
Care for LCD Transmitters in Cold Temperature
In cold temperatures (10 degrees F or below), the Liquid
Crystal Display (LCD) on your transmitter may be dim or
slow to respond. Wait until the display becomes visible before
selecting any training level. Even though the LCD screen
might be dim or slow to respond when you push the Nick or
Constant button, the transmitter will still function properly.
In the occurrence of extremely cold weather, the LCD screen
might take a moment to respond causing the intensity level
to freeze at that current level. In this situation, if you turn the
rheostat intensity dial, the level on the screen may not change
but the actual intensity from the receiver/collar will change in
agreement with the dial. In this situation, it is ideal to either
wait until your transmitter is back to working order before
emitting a correction, or while holding the constant button
down slowly turn the Rheostat Intensity Dial while watching
your dog's reaction. Do not turn the Rheostat Intensity Dial at
a rapid increase because the receiver/collar will emit a static
correction based on the level of the Rheostat Intensity Dial,
49