The Handheld Transmitter Lcd - Dogtra Europe ARC 800 CAMO Manual De Instrucciones

2. Plug the charger into a 120-volt wall outlet or if using
the accessory field charger, plug into a cigarette lighter
only for Lithium-Polymer batteries (use a 230-volt
European charger for Europe.). When properly plugged
in, all indicator lights should glow red. During the
charging process, the unit will shut off. Once the battery
cable is unplugged from the unit after a full charge,
you will need to turn the unit on again before use.
3. The Lithium-Polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process. The red light will change into a steady green light
when the battery is fully charged (when you disconnect
the charger after finishing the charge, you will need to
restart the unit).
4. After charging, cover the battery charging receptacles
with the rubber plugs on the transmitter and receiver/
collar.
NOTE : Only use Dogtra-approved batteries, chargers, and
accessories for your Dogtra e-collars. When a charger is not
in use, disconnect it from the power source.
Charger Info
Manufacturer : HON-KWANG
Manufacturing country : CHINA
Model name : HK-AW-100A150-EU
INPUT : 100~240V~50/60Hz 0.4A / OUTPUT : 10V 1.5A
!
WARNING
During battery charging, the unit must be close to the wall
outlet and the wall outlet must be easily accessible for
security reasons.
44

8. THE HANDHELD TRANSMITTER LCD

Turn the LCD backlight on and off with a short press of
the on/off button.
The LCD screen indicates the stimulation level (0-127).
The LCD battery life indicator shows 3 bars at full charge,
2 bars at medium charge and 1 bar when it needs to be
charged. The battery life indicator only specifies the
remaining charge for your transmitter. To find the remaining
charge for your receiver, observe the LED indicator on the
receiver/collar.
Green = full charge
Amber = medium charge
Red = needs charge
Care for LCD Transmitters in Cold Temperature
In cold temperatures (10 degrees F or below), the Liquid
Crystal Display (LCD) on your transmitter may be dim
or slow to respond. Wait until the display becomes visible
before selecting any training level. Even though the LCD
45