CONTROLS AND FEATURES
(INPUT CARD: OPTIONAL)
SDI INPUT CARD (IF-C01SDG)
SWITCHED
OUT
1
IN
SDI 1
2
IN
SDI 2
4
AUDIO 1
3
IN
OUT
AUDIO 2
Compatible signal formats:
480/60i, 576/50i
HD SDI INPUT CARD (IF-C12HSDG)
Compliant with EMBEDDED AUDIO
E.AUDIO
HD SDI 1
IN
OUT
1
E.AUDIO
HD SDI 2
IN
2
OUT
Compatible signal formats:
720/60p, 1080/50i, 1080/60i, 1035/60i,
1080/24psF, EMBEDDED AUDIO
8
(cont'd)
SWITCHED OUT terminal
1
Output (OUT) terminal for the re-clocked signal. The input signal from SDI 1
or SDI 2 (selected with the INPUT SELECT buttons) is re-clocked and
output from this terminal.
NOTES:
• Even when the input signal is switched from the SDI Input Card, the SWITCHED
OUT terminal still outputs the SDI 1 or SDI 2 re-clocked signal (whichever you
selected last).
• No signal is output from the SWITCHED OUT terminal when the monitor is turned
off or in the stand-by mode.
D1 SDI signal input terminal (SDI 1, SDI 2)
2
Accepts an SMPTE259M compliant D1 SDI signal (component serial digital
signal).
Select SDI 1 input: press INPUT SELECT A (SLOT1)/C (SLOT2)/E (SLOT3) buttons.
Select SDI 2 input: press INPUT SELECT B (SLOT1)/D (SLOT2)/F (SLOT3) buttons.
NOTE:
Not compliant with EMBEDDED AUDIO.
3
Audio signal input/output terminals (for both SDI 1 and
SDI 2)
Input (IN) and output (OUT) terminals for the analog audio signals.
• The IN and OUT terminals are bridge-connected.
4
Connection terminal
Attach to the connection terminal of your Multi-Format Monitor.
HD SDI signal input/output terminals (HD SDI 1, HD SDI 2)
1
Input (IN) and output (OUT) terminals for the HD SDI signal (HD
component serial digital signal)
This card is also compatible with EMBEDDED AUDIO signals with a 48 kHz
sampling frequency and channel range of 1 to 8 channels.
The EMBEDDED AUDIO output channel is controlled from this monitor.
Refer to "EMBEDDED AUDIO channel switch button" on page 4 for more
information.
Select HD SDI 1 input press INPUT SELECT A (SLOT1)/C (SLOT2)/E (SLOT3)
buttons.
Select HD SDI 2 input : press INPUT SELECT B (SLOT1)/D (SLOT2)/F (SLOT3)
buttons.
OUT terminal
The re-clocked HD SDI 1 and/or HD SDI 2 input signal is output from the
HD SDI 1 OUT and/or HD SDI 2 OUT terminal.
NOTE:
• Signals cannot be output from the OUT terminal when the monitor's power is OFF
or in the stand-by mode.
2
Connection terminal
Attach to the connection terminal of your Multi-Format Monitor.