Final Installation - Harbor Breeze WAVEPORT Manual Del Usuario

FINAL INSTALLATION

1. Lift canopy (B) to mounting bracket (C) again,
aligning slotted holes in canopy (B) with loosened
canopy mounting screws (K) in mounting bracket
(C). Twist canopy (B) clockwise to lock. Re-insert
the two canopy mounting screws (K) previously
removed (Step 4a, page 6) and tighten all canopy
mounting screws (K) securely.
2. Partially insert three blade screws (AA) along with
three rubber blade washers (BB) into holes in blade
(G). NOTE: Make sure to attach blade (G) with the flat
side of the blade (G) facing up -- note label indicating
THIS SIDE UP. Align pegs on blade arm (H) with
blade screws (AA), securing blade arm (H) to blade
(G) by tightening blade screws (AA) starting with the
one in the middle.
Repeat for remaining blades (G) and blade arms (H).
Hardware Used
AA
Blade Screw
BB Rubber Blade Washer
3. Attach blade arms (H) to the bottom of motor
housing (D) with motor screws (J) and motor
washers (R) previously removed (Step 5, page 7).
Tighten motor screws (J) securely.
Note: Make sure to completely secure each blade
arm (H) before proceeding to the next.
If you do NOT wish to use the light kit, skip to
INSTALLING FAN WITHOUT LIGHT KIT on page
16.
If you DO wish to use the light kit, proceed to
Step 4.
All manuals and user guides at all-guides.com
x 15
x 15
13
1
Downrod
Option
K
B
B
D
2
AA
BB
H
3
J
R
Lowes.com/harborbreeze
Closemount
Option
K
D
G
D
G
H