Final Installation - Harbor Breeze E-LUK52HBB5LEDR Manual De Instrucciones

FINAL INSTALLATION

1.
Locate two canopy mounting screws (L) on
underside of mounting bracket (C) and remove
canopy mounting screw (L) closest to the open end
of the mounting bracket (C). Partially loosen the
other canopy mounting screw (L). Lift canopy (B) to
mounting bracket (C). Place rounded part of slotted
hole in canopy (B) over loosened canopy mounting
screw (L) in mounting bracket (C) and push up. Twist
canopy (B) to lock. Re-insert canopy mounting screw
(L) that was removed, and then tighten both canopy
mounting screws (L). Slide canopy cover (I) up to
canopy (B), aligning rounded part of slotted holes in
canopy cover (I) with screwheads in bottom of
canopy (B). Turn canopy cover (I) to the right
(clockwise) until it stops.
2.
Partially insert three blade screws (AA), along with
three fiber blade washers (BB), to attach one
blade arm (F) to a blade (G). Then, tighten each
blade screw (AA) starting with the one in the
middle. Repeat with remaining blades (G).
Hardware Used
AA
Blade Screw
BB Fiber Blade
Washer
3. Locate motor screws (DD) and lock washers (EE) in
one of the hardware packs.
Insert two motor screws (DD), along with lock
washers (EE), through one blade arm (F) to attach
blade arm (F) to motor. Tighten motor screws (DD)
securely. Repeat with remaining blade arms (F),
making sure to completely secure each blade arm
(F) before proceeding with the next.
Hardware Used
DD
Motor Screw
EE
Lock Washer
1
L
2
x15
x15
3
x10
x10
11
I
A
F
Lowes.com/harborbreeze
B
AA
G
G
F