Publicidad
Idiomas disponibles
Idiomas disponibles
Y
CAUTION! Before making a cut, make sure that the rotation handle is locked properly and the saw table is secured.
2. MITRE STOPS AND TABLE ROTATION
The table has mitre stops at 0°, 15°, 22.5°, 30° and 45° to the left and right. When you turn the table, it will automatically stop
at the next stop.
To turn the table, make sure the table rotation handle is loose and move the table to the desired angle. Then tighten the
table rotation handle.
3. ASSEMBLING THE SAW CLAMP
and is completely adjustable based on the cut piece.
beforehand.
one of the holes located on the cutting guide and tighten the locking knob (C) against the shank of the clamp.
4. OPERATION OF THE CLAMP
1. The height of the clamp can be adjusted by loosening the locking knob and dragging the body of the clamp up or down.
Once the height of the clamp is adjusted, tighten the locking knob.
2. During operation, place the clamp so that the bottom of the sliding block just touches the top of the piece of wood you are
working on.
3. Finally, tighten the piece against the table, tighten the knob until the piece of wood is completely blocked. Once the cut is
complete, loosen the lock button; you can then slide or remove the piece.
5. GUIDE EXTENSIONS
The cutting guide can be extended sideways for working on large pieces using two extensions (A) Fig.4 that slide outward.
During bevel cutting operations, it is important that these extensions be placed to the outside so that they do not interfere
with the motor housing or the blade guard.
To do this:
The clamp can be mounted to the left or right of the saw
Do not use the saw without having tightened the part
Position the clamp (A) by inserting the rod Fig.3 (B) into
3
30
2
Publicidad
Capítulos
