Publicidad
Idiomas disponibles
Idiomas disponibles
10. Clean the flanges and pour a little oil on both flanges before reassembling the new blade. Install a blade with a diameter
of 255 mm only. Check that the rotation direction of the blade (arrow marked on the blade) corresponds to the direction of
the arrow on the upper blade guard. Make sure the blade is behind the flange.
11. Press the button to lock the shaft(A) Fig.24. Secure the blade in place using the blade change key, and turn the screw shaft
in a counter-clockwise direction to tighten.
12. Replace the lower blade guard and the protective flange in a down position and replace the pan head screw(C) Fig.22the
connecting part(B)and the housing screw (A).
Y
CAUTION!
It is absolutely essential to use blades of the same thickness as the original blade so that the outer flange is held se-
curely on the machine axis during reassembly.
Y
CAUTION!
Unplug the power cord from the power socket before carrying out any repairs or maintenance on the saw. The power cord
must always be unplugged whenever you adjust or carry out maintenance on the machine.
- Only use identical replacement parts with equivalent OEM characteristics to avoid electric shock, fire or personal injury.
- Replace the power cord immediately if it is worn, cut or damaged.
2. SAWDUST
Y
CAUTION!
Wear eye protection when using compressed air to clean your mitre saw.
Empty the dust bag regularly. Avoid the accumulation of sawdust around and under the saw. Use compressed air or a vacu-
um cleaner to keep the area clean.
3. LOWER BLADE GUARD
Y
CAUTION!
Make sure you have unplugged the power cord from the wall outlet before cleaning the lower blade guard.
Regularly check the proper functioning of lower blade guard. Do not use the saw with a damaged or missing lower blade
guard.
The lower blade guard is mounted on the machine for your safety.
Make sure that the lower blade guard is not cluttered with wood dust and that it is clean. Use a damp cloth to remove dust
from the lower blade guard.
NOTE: To avoid damage to the lower blade guard, only clean it with a damp cloth. The use of solvents may damage the plastic
of the guard.
4. MAINTENANCE OF THE DUAL LASER
Y
CAUTION!
Do not look directly at the laser rays. You risk serious injury to your eye by deliberately staring at the laser beams. Read
all of the safety rules concerning the laser.
Check the cleanliness of the laser and remove dust from it if necessary.
1. Turn off the mitre saw and the laser. Unplug the saw.
2. Remove dust from the laser using a soft brush or a clean soft cloth, or a very light blast of compressed air.
5. LUBRICATION
All bearings are permanently lubricated and need not be greased periodically.
40
Publicidad
Capítulos
