Mondolfo Ferro TB125 Manual De Uso página 56

9) Turn the wheel anticlockwise keeping the
lever pressed down until the bead comes out
completely.
10) Move the tool holder arm away to the non-
working position.
Lower the turntable until the wheel presses up
against the mobile platform that, when moved
outward slightly, creates the space needed to
remove the inner tube.
11) Remove the inner tube and lift the wheel
back up.
12) Move the control console to working
position D.
13) Move the tool holder arm to the inner side
of the wheel, turn the tool 180° and lower the
arm to the working position. Insert it between
the rim and bead and move it until the bead
is near the front edge of the rim (it is recom-
mended to perform this operation turning the
wheel at the same time).
14) Move the rim about 4-5 cm away from the
tool making sure the bead does not detach
from the tool.
15) Move the control console to working
position B.
16) Move the hook tool so that its red reference
dot is positioned 3 cm inside the rim.
56
17) Insert the bead lifting lever between the
rim and the bead to the right of the tool (see
Fig. 28).
27
18) Keeping the lever pressed down, lower
the wheel to bring the rim edge about 5 cm
from the hook tool, then turn the wheel an-
ticlockwise until the tyre comes completely
off the rim.
When the beads come off the rim, the tyre
will fall.
Make sure no one is in the work area.
TYRE MOUNTING
1) If the rim has been removed from the turn-
table, reclamp it as described in the "WHEEL
CLAMPING" paragraph.
2) Lubricate the tyre beads and rim using the
recommended soapy solution.
3) Tighten the rim gripper on the outside of the
rim in the highest point (see fig. 29).
WARNING
- E - User Manual TB125
nglIsh
28