Removing The Saddle - Look E-POST 2 EVO Manuales Del Usuario

EN
To remove your saddle, or adjust its position, loosen the screw, a few turns, that holds the upper
brackets in place (11).
Gently apply force, alternating between the front and back of the saddle, to loosen the seat
brackets. If they do not come free, due to over tightening, use a small headed mallet and tap
lightly on the screw head, still bound by a few threads, at various angles in order to free the
opposite side.
INSTALLATION/REMOVAL OF THE E-POST 2 EVO
The tightening of the E-Post 2 EVO is done with a single screw.
1. Insert the seatpost in the frame.
2. Tighten the screws to 4Nm using a torque wrench and a 4mm hex or Allen key.
20

REMOVING THE SADDLE

Fig 10