Tabla De Contenido; Symbols Used In This Document - Grundfos BME Serie Instrucciones De Instalación Y Funcionamiento

English (GB) Installation and operating instructions
Original installation and operating instructions.
CONTENTS
1. Symbols used in this document
2. General information
2.1 Pumped liquids
2.2 Preparation
3. Installation
3.1 Hose for turbine
4. Pipe connection
4.1 Inlet and discharge pipes
5. Electrical connection
6. Motor protection
6.1 Thermistor
6.2 Setting of motor starter
6.3 Generator operation
6.4 Monitoring of oil lubrication system
7. Before starting the booster module
8. Startup
8.1 BME
8.2 BMET
8.3 Operation settings
9. Liquid filling, venting and checking of direction of
rotation
10. Checking of operation
11. Pulleys and V-belts
11.1 Inspection of pulleys
12. Replacement of V-belts
13. V-belt tension
14. Using the tension tester
15. Recommended V-belt tension
15.1 V-belt tension, 50 Hz
15.2 V-belt tension, 60 Hz
16. Oil lubrication system
16.1 Oil change
16.2 Type of lubricating oil
17. Motor bearings
18. Shut-down procedure
19. Periods of inactivity
19.1 Preservation of pulleys and belts
19.2 Startup after a period of inactivity
19.3 Removal of preservative before restarting
19.4 Flushing of the modules
20. Frequency of starts and stops
21. Fault finding
22. Checking of motor and cable
23. Technical data
24. Disposal
4
Warning
Prior to installation, read these installation and
operating instructions. Installation and operation
Page
must comply with local regulations and accepted
codes of good practice.
4
5

1. Symbols used in this document

5
5
Warning
6
6 If these safety instructions are not observed,
it may result in personal injury.
7
7
If these safety instructions are not observed, it
7
Caution
may result in malfunction or damage to the
7
equipment.
7
7
Notes or instructions that make the job easier
Note
7
and ensure safe operation.
8
8
8
8
9
9
9
9
10
10
10
10
11
12
12
13
14
14
14
14
15
15
15
15
15
15
15
16
17
17
17