Attaching The Tip; Operating In Auto Mode - Silk’n ReVit Prestige Manual Del Usuario

y
After treatment, wash the treated area with cold water to remove remaining
U
debris and gently pat dry. Apply a toner, serum or cream to minimize your
pores and soothe your skin for the optimal efficacy of your treatments.
EN
U Light bruising and redness is completely normal after treatments and
should subside within 24 hours. Effective dermabrasion treatments gently
remove the outer layer of skin which may cause slight discomfort and
redness.
Stop using the device immediately if you develop any abnormal reactions
C
such as itching, uncomfortable inflammation, or scratches.

6.2 Attaching the tip

Make sure the device is switched off and unplugged before attaching or
a
changing the tip.
Always make sure a filter and O-ring are in place. Refer to the chapter
a
"Replacing the filter" or "Replacing the O-ring" for replacement if necessary.
1. Attach the desired tip (
2. Make sure the tip is firmly in place before use.

6.3 Operating in Auto mode

Auto mode is only for facial treatments.
1. Press the power button
2. Press the mode button
3. Press the control buttons
Level 1 is the lowest level; while level 3 is the highest level.
4. Press the start/pause button
y
y
y
Neck: Stroke downwards.
8
5
3
Treat the facial area indicated on the LCD display. The LCD display also
shows the countdown of the treatment time for each facial area.
You will hear 2 beeps when the time elapses.
Move to the next facial area indicated on the display after each 2
beeps until the treatment cycle is completed.
During the treatment, you can press the Start/pause button and
then press the control buttons anytime to switch to another facial
area.
9 10 11
/ / / ) to the device.
to switch on the device.
to select "Auto mode" .
6
to select the desired intensity level.
4
to begin the treatment.
8