Audible Continuity; Battery And Fuse Replacement; Replacing The Fuses; Battery Installation - RS Pro RS-9660B Manual De Instrucciones

Heavy Duty True RMS Digital Multimeter / English

Audible Continuity

Audible threshold: Less than 35Ω Test current MAX. 1.5mA
Overload protection: 1000V dc or ac rms.
Accessories
Included accessories
Standard Red/ Black lead set with test probes

6. Battery and Fuse Replacement

WARNING: To avoid electric shock, disconnect the test leads from any source of
voltage before removing the battery door.
1. When the batteries become exhausted or drop below the operating voltage, the battery
warning symbol will appear on the LCD display. The battery should be replaced.
2. Follow instructions for installing battery. See the battery Installation section of this
manual.
3. Dispose of the old battery properly.
WARNING: To avoid electric shock, do not operate your meter with the battery
cover removed.

7. Battery Installation

WARNING: To avoid electric shock, disconnect the test leads from any source of
voltage before removing the battery cover.
Do not operate the instrument with the battery cover removed
1. Disconnect the test leads from the meter.
2. Open the battery cover by loosening the screw using a Phillips head screwdriver.
3. Insert the battery into battery holder, observing the correct polarity.
4. Put the battery cover back in place. Secure with the two screws.
NOTE: If your meter does not work properly, check the fuses and battery to make sure
that they are still good and that they are properly inserted.
12

8. Replacing the Fuses

WARNING: To avoid electric shock, disconnect the test leads from any source of
voltage before removing the fuse / battery cover.
1. Disconnect the test leads from the meter and any item under test.
2. Open the fuse door by loosening the screw on the door using a Phillips head screwdriver.
3. Remove the old fuse from its holder by gently pulling it out.
4. Install the new fuse into the holder.
5. Always use a fuse of the proper size and value (0.5A/1000V fast blow for the 400mA
range, 10A/1000V fast blow for the 10A range).
6. Put the fuse door back in place. Insert the screw and tighten it securely.
WARNING: To avoid electric shock, do not operate your meter until the fuse door is in
place and fastened securely.
16/12/2017 Version No. 001 16/12/2017 Version No. 001
Heavy Duty True RMS Digital Multimeter / English
13