Round Pushbutton With Id Card Reader - ABB M21311P1-A Manual Del Usuario

ABB-Welcome
5.3

Round pushbutton with ID card reader

Programming
Function
Create admin card
Enter settings
The system will take the first card swiped after powering up the system within 60s to be the
admin card.
After enter settings, following functionalities can be implemented:
Function
Enroll user
Delete user
Enroll new admin
Delete admin
Delete all users
During setting, please swipe the same admin card.
Function
Exit settings
Open a door
Function
Open a door
Reset to factory default
Function
Reset to factory
default
|
Command
Swipe card 1x
Swipe admin card 1x
Command
Swipe admin card 1x
Swipe card (new user) 1x
Swipe admin card 2x
Swipe card (user x) 1x
Swipe admin card 3x
Swipe card (new admin) 1x
Swipe admin card 4x
Swipe card (admin x) 1x
Swipe admin card 5x
Swipe admin card 1x
Command
Swipe admin card 1x or no cards
swiped within 15 seconds
Command
Swipe the enrolled keycard
Command
Disconnect the power supply.
Set rotary switches of address to "0"
and set all the dip-switches to "OFF "
Reconnect the power supply
Long press the 1st button for 3s
Finish
Indicated LED for door open
Green
Orange
Indicated LED for door open
Orange flash 1x
Green
Orange flash 2x
Green
Orange flash 3x
Green
Orange flash 4x
Green
Orange flash quickly
Green
Indicated LED for door open
——
Indicated LED for door open
Green
Indicated LED for door open
——
——
——
Green
Red, green, orange cycle
——
— 12 —