Clutch Adjustment - Eurosystems Euro102 Manual De Instrucciones

accordance with the job to be performed. Clean thoroughly the tiller hubs and the hex. shaft section; applicate some grease to make mounting and
tiller future removal easier. Fit the tiller hub (1) to the hex. motor-hoe tiller shaft. Make sure that: the cutting edge of the small hoes is towards the
machine FRONT the bore on tiller hub matches the hole of the motor-hoe hex. shaft. Fasten the tiller to the motor-hoe shaft by means of screw (2),
washer (3) and nut (4). For mounting the other tiller, follow the same procedure as laid down.
USING THE ROTARY CULTIVATOR (Fig. 6)
n
before swtching the engine on , please carefully check the unit to be in good working conditions.
- carefully read the instructions booklet you can find with the engine
- check the air filter to be very well cleaned
- fill the tank in using the kind of fuel that is specified in the engine instructions booklet, using a funnel equipped with filter.
- Do not modify the calibration of the engine speed adjuster and do not allow it to reach high speed.
- How to switch the engine on : open the fuel cock ( for the engines equipped with it ) and put the throttle lever ( you can see on handlebar ) on START
position. In case you need to switch the engine on at cold conditions, please read the engine instructions booklet. Grasp the switching on handle and
give a strong pull to it.
- Forward speed: move the shift rod (3) until the desired gear position, then grip the handles and lift the safety catch (A) that prevents accidental
engagement of the tines. Push the lever forward (B) for its entire run. To engage a different gear you must first release the forward lever B.
- Reverse gear : release the lever forward (B), then position the shift rod (3) in the neutral position. Press the safety pin/lock (C) and pull towards the
reverse lever (D), keeping it pressed the lever also insert lever(B). At this point the machine will start to move reverse direction.
- The present tiller has been designed to reduce the noise and vibration emissions to their minimum levels but we recommend to suspend a long work
with some short breaks.
- End of the work : once you have ended your work , in order to stop the engine , bring the lever (1) on STOP position .
- NOTE : during the first switch on of the day, please let the engine turn for some minutes keeping all the levers on NEUTRAL position. It is also
recommended to perform the a.m. operation even after the running in period.

CLUTCH ADJUSTMENT

n
end all its way. We recommend to verify the correct working from time to time, in case it is not correct please
apply to an authorized servicing centre for the adjustment.
ADAPTING THE DRAWBAR (Fig. 3)
n
shaped safety pin (7); take out lock pin (6) and lower drawbar (5) until the position desired. 2. On hard soils: remove shaped safety pin (7), take out
lock pin (6) and raise drawbar (5) to the position desired.
ADJUSTMENT OF THE HANDLE BAR (Fig. 6)
n
8 positions. Prior to undertaking any job, it is recommended the handlebar be adated to the operator for easier handling any time. 1. Rotate lever (5),
counterclockwise for lock be released. 2. Set handlebar in the position desired (sideways and vertical adjustment are obtaind at the same time). 3.
: after the assembly and adjusting operations the tiller is ready to be used. ATTENTION !
The clutch control must be disengaged only when the handlebar lever is
To obtain a smooth forward movement and a good job, adjust as follows: 1. On soft soils: remove
The handlebar provides for being aligned both sideways and in vertical in a few