Technical Specification - Eurosystems Euro102 Manual De Instrucciones

Have handlebar locked again through clockwise rotation of lever (5), and make certain that teeth mesh accurately. The unit is intended to be used
in an upright manner with the handlebars in a horizontal position in relation to the plane of the earth and in axis with the frame of the machine. For
ease of use in some conditions it is possible to adjust the unit's handlebar (side / up or down). However, please be careful if you are working in any
such adjusted configuration as the distance between the operator and the rotation tools becomes shorter, and thus presents a greater risk of injury.
MAINTENANCE
n
DO NOT WAIT UNTIL THE ROTARY CULTIVATOR PARTS ARE COMPLETELY WORN FROM USE BEFORE CHANGING
THEM. SERVICING THE MACHINE IN GOOD TIME WILL GREATLY IMPROVE MACHINE PERFORMANCE AND WILL ALSO SAVE YOU MONEY
SINCE COSTLY MAJOR REPAIRS CAN BE AVOIDED.
ENGINE MAINTENANCE
n
cultivator.
SERVICING OPERATIONS
n
GARAGING AND SCHEDULED MAINTENANCE
n
a good machine working on safety conditions. Leave the machine to cool before garaging anyhow don't room it if the tank still contains some fuel as
the vapours could reach some blazes or sparks. The fuel tank is to be drained outdoors only. To lower the fire danger , keep the engine, the silencer
and the fuel area free from leaves , grass or greasy substances.
FUEL AND OIL CAPACITY AND FILLING POINTS (Fig. 5)
n
and amount of oil. 2) Fuel tank: capacity: capacity - refer to engine manual. 3) Gearbox: capacity: 2.5 kg; use SAE 85/90 W oil; 4) Oil level dipstick;
vent plug; 5) Engine crankcase: capacity - refer to engine manual.
Gearbox: after 100 hours: change the oil. IMPORTANT! New rotary cultivators are lubricated using the types of oil listed in the section on SERVICING
OPERATIONS. DO NOT MIX DIFFERENT TYPES OF OIL. If you have to use lubricants other than those listed, completely drain the oil contained
and make sure the lubricants selected strictly comply with the characteristics of the original oils. Mechanisms: during the first 80 hours: frequently
check for proper and safe clamping of the mechanisms (tighten down screws, nuts etc. as necessary).
ATTENTION! The used oil must not be drained into the sewer system or waterworks. In order to prevent any pollution to the water-table. Most garages
have used oil deposits, or use the authorized deposits according to your local authority regulations.

TECHNICAL SPECIFICATION

n
dry single-disc type, lever-controlled from the handlebars. Transmission: all gears in oil Gearbox: 3 forward speeds + 1 reverse with safety device.
PTO: fixed speed; gearbox independent. PTO: synchronized with gearbox Handlebars: sideways and height adjustment, quick lock in any positions.
Tiller (Fig.7): fitted with interchangeable hoes. Working width 61 to 125 cm. Provided with protection hood. The working width range being obtained
by adding or removing hoes are shown in figure 7. Weight: with diesel engine: 111 kg; with petrol engine: 95 kg. Tyre inflation pressure (Fig. 8): front
wheels: 1.2 kg/cm ; rear wheels: 1.6 kg/cm
2
NOISE AND VIBRATION LEVEL
n
Engine operating and maintenance instructions are given in the Engine Manual supplied with each rotary
Keep attention that all the nuts, screws and bolts are tightened in order to guarantee
Engine: diesel, petrol, single cylinder, air cooled, self-winding pull starter (refer to Engine Manual). Clutch:
.
2
Measured sound power level with En709, Lwa = 104,4 dB (A), with a uncertainty value K = ±1,5 dB (A).
1) Engine air filter 4T-DIESEL. Refer to the engine manual for the type
9