Magura HYMEC Manual Del Usuario página 10

10
HYMEC-Installation
BIG Twin
hose
Continuation from page before 
18. The assistance of a second person is very helpful for the next step in order to avoid
the loss of fluid! The helper brings the master cylinder from the workbench and holds it
with one hand close to the end of the hose with the open connection facing upwards.
(fig. 5) With the other hand the lever is slowly actuated until fluid can be seen in the
connection. Make sure that no fluid escapes! Then keep the lever in this position. Now
feed the end of line as far as it will go into the connection, keeping it centered and then
push the olive with the retaining nut into the connection and screw the retaining screw into
the master cylinder with a 8 mm wrench, torque the nut to 35 inch pounds. The resulting
deformation of the olive seals the system. The helper can now release the lever. All the
remaining work can be carried out alone.
19. Slip the protective hose over the retaining screw.
20. Attach the master cylinder to the clamp of the mechanical clutch lever on the handlebar.
21. The turn signal can either be attached to the existing OEM adaptor with a mirror attach-
ment screw, or the adaptor can be removed and the ball on the stud of the turn signal
can be inserted into the ball socket of the hydraulic master cylinder and fixed with the
set screw.
22. Tighten the transmission end cover onto the transmission, making sure that a good seal is
maintained. Slip the protective hose over the screw plug.
23. Attach the hydraulic hose to the frame the supplied cable clamp so that the hose cannot be
damaged. Make sure there are no kinks or that the hose can come into contact with any
moving or hot parts.
24. Remove the derby cover on the primary side. (fig. 6) Carefully remove the seal,
taking care not to damage it!
fig. 4
retaining nut
olive
brass end fitting
fig. 5