Publicidad
Step 10
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (M) and lay it over your unit.
Make equal margins along all four edges of the BACK (M).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (M) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the SHELF (F).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
Using your hammer, gently tap six TACK GLIDES (12E)
å
into the bottom edges of the SKIRTS (H and L)
and BRACE (J).
Page 14
These holes must line
up over the SHELF (F).
L
M
J
423410
1N
NAIL
(43 used in this step)
L
H
12E
www.sauder.com/service
Publicidad
