Installation Instructions - Festo CPX Serie Manual Del Usuario

3

Installation instructions

3.1 Fitting
The CPX−FEC is mounted in a manifold sub−base of the
CPX terminal.
1
Screws, tightening
torque 0.9...1.1 Nm
2
CPX−FEC
3
Contact rails
4
Manifold sub−base
(as desired, here as
an example with
additional air
supply)
Dismantling
Remove the screws and lift the CPX−FEC up carefully.
S
Fitting
1. Check the seal and the sealing surfaces and refit the
CPX−FEC.
2. Screws must be inserted so that the self−boring
threads can be used. Tighten the screws in diagonally
opposite sequence at first by hand (Torx T10).
Tightening torque 0.9 ... 1.1 Nm.
Festo CPX−FEC 0404NH English
1
2
3
4
17