Control System Set-Up; Important - Kichler IMARI 65 Manual De Instrucciones

CONTROL SYSTEM SET-UP

IMPORTANT: Ceiling fan blades MUST be installed before pairing
procedure can begin.
Green Light
Program the wall control and/or the handset control separately. Once
the following pairing is successfully done, both the wall control and the
handset control can be used for the fan.
For/Rev switch
Press the power button on wall control to TURN THE POWER ON. The
Light status indicator
LED lights on the wall control will blink thru the power up process,
approximately 3 seconds.
Fan speed indicator
Press the " " power button to turn off the wall control (the button will
be up). Restore electricity to the ceiling fan branch circuit at the circuit
Power switch
breaker or fuse box. Within 60 seconds of turning on the power, press
the " " power button to turn on the wall control (the button will be
down), and then press the " " reverse button for 3 to 5 seconds. Light
will blink twice. The remote will now be programmed to your fan and
ready for use.
IMPORTANT: Do not interrupt the conditioning until the fan comes to a
complete stop in approximately 5 minutes. All functions of the control
Fig. 19
will be rejected during conditioning.
Try different speed setting on both the wall control and the handset
control to ensure the fan is now fully functional. If programming is
unsuccessful, retry the process starting from step 1 again.
16 | KICHLER.COM