Installing The Led Light Kit - Kichler IMARI 65 Manual De Instrucciones

INSTALLING THE LED LIGHT KIT

AND DECORATIVE RING
NOTE: Before starting installation, disconnect the power by turning off
the circuit breaker or removing the fuse at fuse box.
Step 1. Loosen the two mounting screws on the inside of the LED light kit.
(Fig.17)
Step 2. While holding the LED light kit under the fan motor, make the
wire connections: (Fig. 17)
- White to white
- Black to black
Step 3. Tuck the connections neatly into the light plate. Place the LED
light kit close to the light plate, secure by tightening the two screws.
(Fig.17)
Step 4. Position the notches in the decorative ring so they line up with
the tabs on the LED light kit. Carefully lift the decorative ring up inside
the light kit and secure it to the fan by turning the decorative ring
clockwise until snug. DO NOT OVERTIGHTEN. (Fig. 18)
Wire connectors
LED light kit
Fig. 17
Decorative ring
Fig. 18
Light plate
Screws
Light kit
65" IMARI | 15