Control System Set-Up; Operating Instructions - Kichler 52 Chiara Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CONTROL SYSTEM SET-UP

Step 1. After installation is complete, press the LEARN button for 3 seconds within 30 seconds
once AC power is turned on. Fan will turn on at medium speed and light (if installed) will turn on.
This confirms that the SMART SYNC setting is active and ok. (Fig. 20)
Step 2. If you cannot finish the setting within the 30 seconds time frame, the main power must
be turned o and re-started again. This will repeat step 1 until the LEARN feature is activated as
indicated.

OPERATING INSTRUCTIONS

Restore power to ceiling fan and test for proper operation (Fig. 20)
1. Fan Control: To start the fan. Press the selected speed button to run the fan at the desired
speed: Hi-high speed; MED-medium speed; LOW-low speed; Press the "FAN OFF" button to
turn o the fan.
2. Light button: Press once to turn the light on or o . Continuous pressure on the light button
dims light in a continuous cycle from light to dark, or dark to light.
3. If your ceiling fan has fluorescent lighting, please slide the switch to "O" position. If the ceiling
fan has incandescent or halogen lighting or LED, please slide the switch to "D" position.
4.REV switch: Controls direction, forward or reverse. (Fig. 21)
NOTE: The reverse switch is located on the LED light kit, remove the shade to access the switch.
Slide reverse switch to change fan rotation.
NOTE: Wait for fan to stop and shade to be cool before reversing the direction of the blade
rotation.
Learn
ON/OFF
Fig. 20
REV Switch
LED Light Kit
Fig. 21
52"
Chiara
LED
15

Publicidad

Tabla de contenido
loading

Tabla de contenido