Control System Set-Up - Kichler cULus 300285/85-GENT Serie Manual De Instrucciones

CONTROL SYSTEM SET-UP

IMPORTANT: Ceiling fan blades MUST be installed before pairing
procedure can begin.
Program the wall control and/or the handset control separately.
Green Light
Once the following pairing is successfully done, both the wall control
and the handset control can be used for the fan.
Press the power button on the wall control to TURN THE POWER
ON. The LED lights on the wall control will blink thru the power up
For/Rev switch
process, approximately 3 seconds.
Press the " "power button to turn off the wall control (the button
Light status indicator
will be up). Restore electricity to the ceiling fan branch circuit at
the circuit breaker or fuse box. Within 60 seconds of turning on the
power, press the " " power button to turn on the wall control (the
button will be down), and then press the " " reverse button for 3 to 5 Fan speed indicator
seconds. Light will blink twice. The remote will now be programmed
to your fan and ready for use.
Power switch
IMPORTANT: Do not interrupt the conditioning until the fan comes
to a complete stop in approximately 5 minutes. All functions of the
control will be rejected during conditioning.
Try different speed setting on both the wall control and the handset
control to ensure the fan is now fully functional. If programming is
unsuccessful, retry the process starting from step 1 again.
Fig. 19
17
60"/65"/85" GENTRY