Control System Set-Up - Kichler 56 ICON Manual De Instrucciones

CONTROL SYSTEM SET-UP

WARNING: Chemical Burn Hazard. Keep batteries away from
!
children.
WARNING: Make sure the power is completely disconnected
!
before you begin this procedure.
SPECIAL NOTE: Your new Kichler® Ceiling Fan is state of the art
and employs a high efficiency DC (direct current) motor with an
advanced CoolTouch™ remote control system. The DC motor
uses 70% less energy than a conventional ceiling fan AC induction
motor. The DC motor is "digitally" controlled and operates
differently than conventional ceiling fan motors.
Please read this portion of the manual completely before
proceeding.
Our CoolTouch™ Control System includes an "automatic
frequency selection" feature. To set the control frequency and
program the control system, follow these steps:
Open the back of the transmitter by loosening the screw (figure
21). The frequency selector is a "dip switch block" inside the
battery compartment of the transmitter (see figure 22). You
change frequencies by arranging the small switches numbered
1 through 4 in a up or down position. 16 Possible frequencies
or combinations are possible. The fifth switch, marked D and X
sets the system for operation with incandescent or fluorescent
lamps. It is essential to set this switch correctly. If your ceiling
fan is equipped with incandescent lamps set this switch to the D
position, for fluorescent lamps, set the switch to the X position.
If these settings are reversed, the lighting control system will
operate erratically and could damage your ceiling fan.
WARNING:Chemical Burn Hazard.Keep
batteries away from children.See Manual
WARNING:Chemical Burn Hazard.Keep
batteries away from children.See Manual
Model : UC7214T
FCC ID : CHQ7214T
ON
ON D
1 2 3 4 X WARNING:Chemical Burn Hazard.Keep
batteries away from children.See Manual
Dip switch
Model : UC7214T
FCC ID : CHQ7214T
56" ICON |
Fig. 21
Fig. 22
17