jbc advanced AM 6500 Serie Manual De Instrucciones página 18

Changing the handpiece's cartridge
With the Advanced system, the cartridge can
be changed quickly, without turning off the
station, so you have two soldering irons in one.
Here is what to do to change the cartridge: : : : :
1 - Place the handpiece and remove the
cartridge.
2 - Place the handpiece on top of the new
cartridge, press it slightly down and remove
the handpiece.
3 - Press the cartridge into the opening A, B or C:
A. For straight 2210 cartridges.
B. For curved 2210 cartridges.
C. For 2245 cartridges.
Alignment
Important.
- It is essential to insert the cartridge till the
end for a good connection. Take the mark
as reference.
Advanced series cartridge
The cartridge is made of the heating element
which has the heating system, a temperature
sensor and a long life tip.
The long-life tip is basically made of:
1 Copper
2 Iron
3 Chromium
4 Tin plate
Tip care recommendations
Except for the copper core, the rest of metals
are placed galvanically on relatively thin layers,
therefore it is necessary to avoid anything
which could cause their destruction.
To clean the tips, use the sponge included with
the stand and check that it is slightly moisted.
Only deionised water (car battery water) should Only deionised water (car battery water) should Only deionised water (car battery water) should
Only deionised water (car battery water) should Only deionised water (car battery water) should
be used in order to wet the sponge be used in order to wet the sponge be used in order to wet the sponge. If normal be used in order to wet the sponge be used in order to wet the sponge
water was to be used, it is very likely that the tip
will become dirty due to the salts dissolved within
the water.
To re-tin the soldering tips, we recommend
using the TT 9400 tip tinner/cleaner ref. 9400000.
17
ENGLISH