jbc advanced AM 6500 Serie Manual De Instrucciones página 8

There are different models of protectors and
extractors as accessories.
The measurements of all the extractors and
protectors are given on page 99 of instructions
manual.
C) Tripod:
For small components for which an extractor
cannot be used, we recommend use of tripod 20
Ref. 0932050, as shown in the figure.
Use the tripod 40 Ref. 0932250 for larger integrated
circuits.
SOLDERING PROCEDURE
1 After desoldering the component, any solder
left on the printed circuit should be removed
with our DR 5600 desoldering iron ref. 5600000.
2 Place the component or printed circuit with
the MP 2260 Pick & Place ref. 2260000.
3 When the component is correctly placed,
solder its pins.In the case of integrated circuits
of the Flat Pack type, first solder one pin of
every IC angle to fix it in place in the circuits.
4 Apply FL 9582 flux ref. 0046565 in pads and
leads.
5 Solder the remaining pins. For this we
recommend to use our soldering irons of the
Advanced series, which are available in two
different models:
7
ENGLISH