Electrolux EHF6343FOK Manual De Instrucciones página 25

Problem
Residual heat indicator
does not come on.
Automatic Heat Up function
does not operate.
You cannot activate the
outer ring.
There is a dark area
on the multiple zone.
The sensor fields become
hot.
comes on.
comes on.
and a number come on. There is an error in the hob. Disconnect the hob from
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also three
digit letter code for the glass ceramic (it is
in the corner of the glass surface) and an
Possible cause
The zone is not hot be-
cause it operated only for a
short time.
The zone is hot.
The highest heat setting is
set.
You decreased the heat
setting to .
It is normal that there is a
dark area on the multiple
zone.
The cookware is too large
or you put it too near to the
controls.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
error message that comes on. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about
the Service Centre and conditions of
guarantee are in the guarantee booklet.
ENGLISH
Remedy
If the zone operated suffi-
ciently long to be hot,
speak to an Authorised
Service Centre.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the
function.
Start from and only in-
crease the heat setting.
Activate the inner ring first.
Put large cookware on the
rear zones if possible.
Deactivate the hob and ac-
tivate it again.
Refer to "Daily use" chapter.
the electrical supply for
some time. Disconnect the
fuse from the electrical sys-
tem of the house. Connect
it again. If comes on
again, speak to an Author-
ised Service Centre.
25