Recording; Recording A Tape On Deck B - JVC MX-GA8 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Recording

IMPORTANT:
• It may be unlawful to record or play back copyrighted
material without the consent of the copyright owner.
• The recording level is automatically set correctly, so it is
not affected by the VOLUME, the SUBWOOFER LEVEL,
and the SOUND MODE controls. Thus, during recording
you can adjust the sound you are actually listening to
without affecting the recording level.
• While recording, you can hear the SOUND TURBO effect
through the speakers or headphones. However, the sound is
recorded without this effect (see page 10).
• If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Place the unit away from
the TV.
• You can use type I tape for recording.
To protect your recording
Cassettes have two small tabs on
the back to protect unexpected
erasure or re-recording.
To protect your recording,
remove these tabs.
To re-record on a protected tape,
cover the holes with adhesive
tape.
To keep the best recording and playback sound quality
If the heads, capstans, and pinch rollers of the cassette decks
become dirty, the following will occur:
• Impaired sound quality
• Discontinuous sound
• Fading
• Incomplete erasure
• Difficulty in recording
To clean the head, capstan, and pinch roller
Use a cotton swab moistened with alcohol.
Erase head
Head
To demagnetize the head
Turn off the unit, and use a head demagnetizer (available at
electronics and audio shops).
21
Capstan
Pinch roller

Recording a Tape on Deck B

On the unit ONLY:
1
Press EJECT 0 for deck B.
2
Put a recordable cassette in, with the exposed
part of the tape down and the side you want
to record facing front.
3
Close the cassette holder gently.
4
Start playing the source—FM, AM, CD
player or auxiliary equipment connected to
AUX IN jacks.
• For duplicating tapes, see "Dubbing Tapes" on page 22.
• For recording from CD, see "CD Synchronized
Recording" on page 22.
5
Press REC START/STOP.
The REC (recording) indicator lights up on
the display and recording starts.
To stop during recording, press REC START/STOP again
or 7.
To remove the cassette, press EJECT 0 for deck B.
REC START
/ STOP

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Sp-mxga8Ca-mxga8

Tabla de contenido